There is online and also offline version. The first tool is Microchip Advanced Parts Selector (MAPS) tool. Last week, I noticed handy tools in Microchip website. Selecting a right MCU and checking features while developing is a time consuming task sometimes. I used PIC as my primary development platform for years. I renamed it USBPICProg because it is no more GTP-USB Lite. LED shows signal now.įor now, I can use reborn USBPICProg as a backup programmer. The PC USB port will detect and installed new device (USBPICProg) driver.īefore final launch, I simply cut the trace between LEDs and RB7,RB6 (pin 27,28) and connected LED’s resistors to Pin 11,12. Connect PGC pin (RB6, Pin No 27 of PIC18F2550) to ground to de-activated the bootloader and activated USBPICProg programmer mode. – USBPICProg-0.6.0-software –> Updated Firmware Launch the PC programmer software and bootloader is activated and update firmware. The PC will detect bootloader and install bootloader USB interface driver. – Download last firmware and attached programmer. – Download and installed PC software and install it. – First, to take off and flash programmer’s PIC18F2550 with boot loader and to change 12MHz crystal in circuit USBPICProg hardware , firmware, PC software (The best thing is all are opensource :D)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |